licence code

General CutViewer questions

licence code

Postby morpheus971 » Tue Dec 13, 2016 5:04 pm

i buy cutviewer more than 24 h

but i do not receive my licence code

what's going on ?
morpheus971
 
Posts: 3
Joined: Tue Dec 13, 2016 4:56 pm

Re: licence code

Postby Randy » Tue Dec 13, 2016 6:29 pm

Hi morpheus971, and welcome to the forum. I would suggest sending an email to the MeshCAM support address and ask. I know that Rob is very busy these days and might take a little while to respond.

Randy
All opinions in this post are mine alone. I am not a MeshCAM employee, I do not have a financial interest in MeshCAM, nor do I speak for MeshCAM. MeshCAM user since Beta 5 in 2003. viewtopic.php?f=11&t=15333 :ugeek:
Randy
 
Posts: 1797
Joined: Wed May 14, 2008 9:50 am
Location: North Texas, USA

Re: licence code

Postby morpheus971 » Wed Dec 14, 2016 7:05 pm

tanks randy all is fine now !

now i have another problem : i work on a portable computer running windows8 64bits

i put this instructions in cutviewer and nothing happen:

;STOCK/BLOCK,375,215,75,0,0,0
;FROM/0,0,76
;TOOL/MILL,20,0,100,0
;color/0,255,0

the screen stay the same : four bleue screen ! no stock appear !

what is the problem ? can you help please?
morpheus971
 
Posts: 3
Joined: Tue Dec 13, 2016 4:56 pm

Re: licence code

Postby morpheus971 » Wed Dec 14, 2016 7:48 pm

all is fine ! i put cutviewer on 16 bit color,and its works
morpheus971
 
Posts: 3
Joined: Tue Dec 13, 2016 4:56 pm

Re: licence code

Postby Randy » Wed Dec 14, 2016 8:14 pm

That's good! I'm away from my PC with CutViwer, and had to find a copy of the manual online. Those lines look OK to me, and apparenly are! What was the color depth before you set it to 16-bit?

Randy
All opinions in this post are mine alone. I am not a MeshCAM employee, I do not have a financial interest in MeshCAM, nor do I speak for MeshCAM. MeshCAM user since Beta 5 in 2003. viewtopic.php?f=11&t=15333 :ugeek:
Randy
 
Posts: 1797
Joined: Wed May 14, 2008 9:50 am
Location: North Texas, USA


Return to General

cron